Lumenok Gt Laser Ii & Iii Flat Nock
For Gold Tip Laser II & III crossbow bolts.
Customers also bought
Send to friend
Camo Polycotton Bow Sleeve
- 52" x 17-1/2".
- Durable lightweight camouflage material.
- Full length YKK zipper.
- Folds to pocket size when not in use.
- Meets state bowcase requirements.
- Works well for parallel limb bows.
- Advantage Max4 HD.
S&s 37 Degree Black Ultra Lite Peep
- Only 7.5 grain.
- Approximately 25% lighter then the original Super Peep Housing.
- Accepts all Specialty apertures, 1/8" and smaller clarifiers, and 1/8" verifiers.
- 37 degree for shorter bows.
- 45 degree for longer bows.
- Black - 37 degree.
Nap Quickfletch W/blazer Vanes White/green/green
- The easiest way to fletch your arrows in less than 10 seconds and guaranteed not to slip.
- They shrink to fit any size arrow shaft.
- Available in NAP Quikspin Speed Hunters,Twister Vanes and Bohning Blazer Vanes; either white or black tubes.
- Available in 2" only.
- 6 pack.
Bowtech Ultra Rest Left Hand Mossy Oak Infinity Camo
- Total arrow containment, the arrow will never fall off.
- Drop away rest with total fletching clearance.
- Lock Down technology guarantees no bounce back and total fletching clearance.
- Shoots with launcher in 90 degree position.
- Drops only when bow is fired.
- Noise reducing, laser cut felt and rubber dampeners.
- Tested at over 400 fps with total fletching clearance.
- Lower valley launcher for perfect berger hole alignment with no launcher - bow shelf contact.
- Custom mounting block machined for Bowtech.
- Logo decal hides mounting block bolt.
- Seamless fit to Bowtech risers.
- No extra parts needed for perfect center shot alignment.
- Non slip mounting block system.
- No set screw required.
- Made in the USA with a limited lifetime warranty.
- .946" distance between the mounting block hole and the vertical screw.
- Mounting bolt slot is larger.
- Mounting block overall size is slightly larger.
- These rests will fit every Bowtech bow from 2009 all the way to the Prodigy and Boss models.